Home > Fertiliser > GPS > V3 GPS Interface
Interfacing a V3 Spreader Control System is a simple, straight forward process.
Below is an outline of the steps required to interface a V3 spreader Control System to a GPS system.
- Step One
- Contact JWE to arrange an interface cable that will best suit your setup.
- Step Two
- Check the V3 Spreader Control System's software version.
- The latest V3 systems are already compatable, while some of the older versions will require a free software upgrade. If your V3 system is very old, there is a chance a minor hardware change will be required at a small cost.
- Step Three
- Turn on the GPS function in the settings and set the correct communication baud rate.
If you need a GPS Interface cable or any other information please feel free to contact us